Request my free trial
Help center

Counter

Self-check-in with the till code

Letting the customer confirm their own visit with the till code displayed at the counter, and the limits against abuse.

With self-check-in, the customer confirms their own visit: they scan your QR code (or hold their phone up to your NFC card or sticker), then enter the till code you display. Handy when there is a queue.

Switching check-in on (owner)

  1. Open Settings, the Check-in at the till section (Loyalty programme group).
  2. Under Self-check-in (scan page / NFC), tick Allow customers to check in their own visit.
  3. Enter a Till code (4 digits), or tap Generate.
  4. Tap Save.

With several points of sale: in the Points of sale section, each site can have its own Site till code. A visit checked in with that code is attached to that site; the general code stays valid everywhere. The box above must stay ticked. A site code can be 4 to 6 digits long.

Where to display the code

The code is not printed on the QR poster: write it next to the QR code or the NFC card (counter, chalkboard, till screen). Change it from time to time in Settings › Check-in at the till, especially if you think it is getting around.

What the customer does

  1. They scan the QR code on the counter.
  2. If their phone already knows their card, they tap Confirm my visit. Otherwise, I already have a card (with their phone number) or I'm new.
  3. In the Check in my visit block of their card, they enter the code then tap Confirm.
  4. They see "+1 stamp! Visit recorded." and, where applicable, the reward unlocked with its code. Their Wallet card updates.

Limits against abuse

  • One visit checked in per customer per day: "Visit already checked in today".
  • Wrong code: "Incorrect code".
  • 10 attempts at most per 10-minute window from the same connection, then "Too many requests, try again in a moment".
  • Check-in only works with an active subscription.

Good to know

  • Points card: the customer does not enter an amount, so the check-in counts the visit without adding any points. Record purchases in the Till instead.
  • The one-visit-a-day limit only applies to self-check-in, not to the till.
  • These visits appear as Visit (customer check-in) in the customer's history and as Customer check-in in the analytics.

Updated on 5 November 2026

Was this article helpful?

In the same section

Can't find the answer?

Already a customer? Click “Aide” in your merchant space: the assistant checks your account, and a human takes over if needed.

Write to us

Your cookies, your choice. Only cookies the site needs, cookie-free audience measurement, no advertising cookies. Privacy policy ·